Logo
FULL SITE MENU

Recent content by bassforme

  1. B

    carb kit question

    1996 Mercury 40 4 cylinder 2 stroke carbs are WMA-9-10-13 are the sierra carb kits any good compared to the quick silver ones about 30 bucks differance...what do people buy Thanks
  2. B

    90's merc 40hp 4cyl 2 carb question

    when at idle on muffs what results should i get when placing my hand over top carb? and on the bottom carb? trying to figure out why I have good idle at home muffs or barrel but hard to get her to run at the lake.when on the lake I have to tilt the motor up to start and then lower motor and good...
  3. B

    tilt trim rod scrapper

    96 mercury 40hp 4 cylinder model 0G265924 got the piston rod off but can't seem to get the end plate off so I can put the new scrapper and 0 rings in(mine doesn't have a bolt on the end).I tried lightly with a vice and wood but wouldn't budge, is there a special tool for this...don't want to...
  4. B

    water pump question

    hello to all, I have a 199ish Mercury 40hp 4 cylinder 2 stroke seriel # 0G26592. just bought a tracker pro 18 and I used it 3 times.noticed it wasn't peeing right and at times would stop completely so I bought a water pump and impeller installed seemed all went well,hooked up rabbit ears started...
  5. B

    mercury 40 hp 4cylinder 2 stroke carb issues

    2 months ago I bought a 1996 bass tracker started and ran fine until I wanted go faster it bogged and ran but wasn't going fast so I decided to push the key choke in and it took off, released choke and and would go half speed.I thought the carbs were dirty so I cleaned them up all looked pretty...
See more
Back
Top