Logo
FULL SITE MENU

Recent content by avh

  1. A

    BF50D Fuel pump issue

    First up take lots of pics on your phone so you can see how it all goes back so the timing belt cover comes off 4 bolts on a plastic cowling Fuel rail has a single bolt holding on the high pressure fuel line fitting and 2 bolts holding down the fuel rail. fuel injectors need unplugging. intake...
  2. A

    BF50D Fuel pump issue

    Part #27 is the bit you want to cut back. Trim back to the ribbed section of the grommet. Disconnect battery Remove cowling Remove fuel rail Remove intake and note where the vac lines go Remove the 2 bolts holding on the VST and pump housing. Open up pump housing 5 bolts Unscrew pump cage 3...
  3. A

    BF50D Fuel pump issue

    Gentlemen, thank you.from the bottom of my heart. Had the same High pressure pump outlet grommet issue. Took it apart and measured the grommet length compared to the cavity it sits in with micrometers and sure enough, it was bottom out. I cut back the end section so is bottoms out of the top...
  4. A

    BF40D NMEA issues

    Hi peeps. Doing a service on the boat and also changing gauges to NMEA. I have the backbone installed and powers. Have a Garmin 75 and KUS NMEA gauge that can see each other on the network, so I think I can rule out a setup issue. However, the engine won't register on the network. I've check...
See more
Back
Top