Logo
FULL SITE MENU

Recent content by audyva

  1. A

    Evinrude lightwin 3602

    Hello. i have an issue with my Evinrude lightwin 3602. It will run at high speed, to get it to run at high speed, i need to open and close the choke for about 5min. I am having problem adjusting the low speed needle, initial setting is 1 and a half turn. The carb was rebuild, also points...
  2. A

    Johnson 2hp 2R71A

    No the spark plug is dry. I have tool that i attached to the spark similar to this that i use test for spark Maybe i should replace the spark plug, since it's pretty much the only thing i did not order for replacement.
  3. A

    Johnson 2hp 2R71A

    Hello, I just did a complet rebuild of my Johnson 2hp 2R71A and it will not start. I have replaced all gasket and pisto ring, also have about 90psi of compression. New coil, points and condenser, the point gap is set to .020 First initial high and low speed needles that i used is this...
  4. A

    Evinrude/Johnson 2hp

    Hi everyone, Thank you for adding to your blog. I am searching for advice, i have 2x 2hp motors, one Evinrude and one Johnson, both of them are from the 1970's i think. I sent them to a local repair shop and they told me that they are finished and not worth spending money to repair them. The...
See more
Back
Top