Logo
FULL SITE MENU
J

jgmo

Silver Medal Contributor From temecula, ca., usa
Joined
Last seen
Messages
6,583
Reaction score
1

Latest activity Postings About

    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Yes, you need to first fix the stuff you know needs fixing. Otherwise, you could wind up going in circles, chasing your backside. These...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      I'm not sure why it's doing the cut off thing. Cutting off after running hard and then restarting immediately after could have a...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Something I should have asked in the beginning: Are you the original owner? AND Where do you normally use the outboard? .Actually, at...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      HI, Well, you might have a bit of blockage in that primary jet circuit. That's my first guess. I own TWO good quality ultrasonic...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Ok, that makes sense. Glad you finally figured that out. That main emulsion tube typically falls out on it's own when the plug holding...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      So, you're saying that the top of the main emulsion tube snapped off and was stuck in the hole?? If so, that's a new one for me.
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Ok, once again I'm confused/not understanding. I thought you indicated that you can't remove the slow jet tube. Is that wrong? If you...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Ok, once again I'm confused/not understanding. I thought you indicated that you can't remove the slow jet tube. Is that wrong? If you...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Hi, It can be very difficult getting this model carb "straigtened out" after it's been allowed to get "plugged up" or worse, mishandled...
    • J
      jgmo replied to the thread Getting my 20 running again!!.
      Hi, DId you remove the plug that holds the emulsion tubes up? Your question confuses me because I don't see how you could have taken a...
    • J
      jgmo replied to the thread 2005 BF90 warm restart issue.
      Just a guess but you might want to have a look at the valve adjustment. Tight valves can affect starting. During "break in", an engine...
    • J
      jgmo replied to the thread Honda 150 hp BAPJ crank/no crank.
      Something "quick and dirty" you can try to find if its a bad batt cable is to overlay a jumper cable from battery to starter. I do that...
    • J
      jgmo replied to the thread BF60A trim problems.
      Hi, I don't have quick or surefire answer for you. My experience with trim "repair" is putting seals or motors and brushes in a few...
    • J
      jgmo replied to the thread Honda 150 hp BAPJ crank/no crank.
      Hi Allois, My first suspect for this would be poor battery cable connection or defective battery cable. It could be on the positive...
    • J
      jgmo replied to the thread BF20 overheating.
      See item 8 in link for the temp sensor in question. Good luck...
    Show older items
  • Loading…
  • Loading…
Back
Top