weber 38 dges (weber k861) throttle linkage

[connyjonsson]

Hi everyone!

I have just installed my new weber 38/38 dges on a penta aq151b (bought the weber k861) , works fine, and run smooth.

Only one thing left, does any one know or have some pictures on the throttle linkage, i have read it before in some threads here
but the link to the photos seems to be old.

Many thanks for tips..

 

[connyjonsson]

If anyone got pictures.

Email me on [email protected]

 

[sandkicker]

How about a picture or two from you as to what it looks like now with what you have? Someone may be able to make some suggestions.

 

[connyjonsson]

Hi!

Good point, here is one pic, I can upload more later.

 

[robj]

Here you go.

 

[robj]

Hope those help. There are two unused bolt holes at the top of the block that I used. Then I used two horizontal supports for strength and to make it rigid. Mine is pretty well a vertical pull, which is what you want. Unfortunately there is some welding involved. Did it probably 4 years ago and never had any issues. Good luck and feel free to ask any questions. I do not visit this forum as much as I used to but I will check back.