Was out on the lake the other day and my haul started to fill up with lake water.
Water was dripping from out of a hole from the lower flywheel housing ring gear bottom cover.
Not sure if a bolt fell out ,or this is a weep hole like you find on a water pump.
Anyways i tried to screw in a bolt ,but could not feel any threads,very hard to reach under .
I did take a piece of rubber and shove it in the hole so you can see it in the picture .
What is the hole ? Should there be a bolt in it ?
Below is a picture. You can see a bolt to the left and a piece rubber to the right.
I have a feeling my seal for the drive shaft is leaking.
Water was dripping from out of a hole from the lower flywheel housing ring gear bottom cover.
Not sure if a bolt fell out ,or this is a weep hole like you find on a water pump.
Anyways i tried to screw in a bolt ,but could not feel any threads,very hard to reach under .
I did take a piece of rubber and shove it in the hole so you can see it in the picture .
What is the hole ? Should there be a bolt in it ?
Below is a picture. You can see a bolt to the left and a piece rubber to the right.
I have a feeling my seal for the drive shaft is leaking.
Last edited: