Barnacle Bob
New member
I have a 1989 Evinrude 25 hp (TE25ELCEB). It has a new fuel pump, electric primer is working, rebuilt and cleaned the carb. Also has a new ignition module, stator, ignition coils, spark plug wires and plugs. It's getting a spark that jumps a 1/2 inch gap on both. Compression is 120 in each cylinder. Timing is good, linkage is set according to the manual. Despite all this, it won't crank over. When I pull the plugs after cranking, they're wet, so I think I've got fuel, and it's fresh fuel with a 50:1 gas to oil mixture. I'm completely baffled as to where to go next.