1989 Johnson 110 Crossfire. Hooked up a bump starter switch to check spark, timing etc. and no response. I tested the solenoid per the OMC manual and it passed the two tests. Both tests are done with all wiring disconnected. First test is continuity between the two large terminals. It is supposed to have no continuity and it does not. Second test is apply 12V to the small post (the one the yellow wire connects to) and ground to the other small post. The solenoid should energize (loud click) and have continuity between the two large terminals. As mentioned, it passes that test. When I hook all the wires up and activate the bump starter there is 12.75V at the A terminal, 12.55V at the small post the yellow wire attaches to but no voltage passes to the larger B terminal attached to the starter. Can the solenoid be bad but still pass the two tests prescribed in the OMC manual?