Hi Guys, I am looking for a little help. I was out on the water last night and my long shift cable broke about 8 inches from the controls. I took the controls apart and the splines look worn also so I have decided to change the complete control unit. It is a quicksilver control unit with my trim button built in to the top of the handle. The controls have been getting stiff, which I guess was the cable chafing inside the casing. The cable broke right at the bend where it leaves my controls and goes aft to the engine. The cable is a simple fix but i am wondering what a good replacement would be for this quicksilver unit. There is a unit made by TELEFLEX , CH7600, but I am unsure if I can use it with my merc cables. Does anybody have any ideas or info that could help me out.It would be greatly appreciated.