Am in the break in process of
Am in the break in process of a re-built power head. Am told that 10 hours is enough break in time. I am using a 50 to 1 fuel mixture. I have been keeping the rpm at 4500 or below.
After the 10 hour period should I change fuel mix to different level for a period of time or is the injected oil enough at this point? How soon can I increase the rpm? Is there a maximum rpm? The new pistons are .50 over.
I appriciate the help and expert advice given here on this site.
Am in the break in process of a re-built power head. Am told that 10 hours is enough break in time. I am using a 50 to 1 fuel mixture. I have been keeping the rpm at 4500 or below.
After the 10 hour period should I change fuel mix to different level for a period of time or is the injected oil enough at this point? How soon can I increase the rpm? Is there a maximum rpm? The new pistons are .50 over.
I appriciate the help and expert advice given here on this site.