jamesmichaeltaylor75
New member
"New guy here, and I purchased
"New guy here, and I purchased a boat about 6 months ago. It's a beautiful aluminum v-hull with a 50 hp yamaha 2-stroke motor. The boat sat up for quite some time, as the previous owner was an elderly gentleman, and couldnt get out much. To make a long story short, I've searched the forums, and everything that I've tried still isn't working. I can start the motor no problem. I've ran a can or 2 of deep creep through the carbs, and with the cover off of the motor, it will run like a spotted ape!!!! When I put the cover back on the motor, and try to throttle up from idle, I can never get past a low rpm without it dying. The motor has low hours, it just won't run properly in the water. Any advice would be greatly appreciated!!!!!!
"
"New guy here, and I purchased a boat about 6 months ago. It's a beautiful aluminum v-hull with a 50 hp yamaha 2-stroke motor. The boat sat up for quite some time, as the previous owner was an elderly gentleman, and couldnt get out much. To make a long story short, I've searched the forums, and everything that I've tried still isn't working. I can start the motor no problem. I've ran a can or 2 of deep creep through the carbs, and with the cover off of the motor, it will run like a spotted ape!!!! When I put the cover back on the motor, and try to throttle up from idle, I can never get past a low rpm without it dying. The motor has low hours, it just won't run properly in the water. Any advice would be greatly appreciated!!!!!!