I am preparing my 1977, 6hp, for the next season.
Took the lower unit off and dig in the water pump.
Surprisingly, the is no gasket between the steel plate and the plastic impeller housing.
Part diagram show no gasket for the 1977 and 1978 models, a new design appears in 1979
Do you advise me to reassemble as is (no gasket, just 4 srew holding down the impeller housing)
Is this ''no gasket'' situation a source of problem eventualy?
Thank for your advice
Normand
Québec
Took the lower unit off and dig in the water pump.
Surprisingly, the is no gasket between the steel plate and the plastic impeller housing.
Part diagram show no gasket for the 1977 and 1978 models, a new design appears in 1979
Do you advise me to reassemble as is (no gasket, just 4 srew holding down the impeller housing)
Is this ''no gasket'' situation a source of problem eventualy?
Thank for your advice
Normand
Québec