tboltmike
Regular Contributor
I just had the EMM replaced on my '09 ETEC 130, E130DSLSE.
The first trip out, it only would develop 4900 rpm and was about 5-8 miles slower than normal speed. Ran at various speeds with several stops for about an hour.
Took it out the next day and right off, after about 10 min at idle and slow speed, it ran 5600 and normal speed.
Does it take a while for the new emm to learn the engine. Same exact load and section of still bayou and wind.
Thanks for any insight
The first trip out, it only would develop 4900 rpm and was about 5-8 miles slower than normal speed. Ran at various speeds with several stops for about an hour.
Took it out the next day and right off, after about 10 min at idle and slow speed, it ran 5600 and normal speed.
Does it take a while for the new emm to learn the engine. Same exact load and section of still bayou and wind.
Thanks for any insight