Hello, everyone.I have seen the topic of the older unregulated cdi systems over charging sometimes up to 16+ volts.And i think it is getting to be more and more of a prob with the newer batteries not allowing voltage leakage.I havea 1970 60 hp I picked it up out of a barn it needed a lot of tlc And as the project went on and on with part after part all new fuel and carbs. New ele parts I get it up and runnin and she ran great exept for the hinderence to watch my volt gauge peg out in the red zone when i get the rpms up over 3500-4000 15+ volts then at wot 52-5500 rpms16-17+ volts not good.I am running the dual pergo switch with a wally world everstart max 27 not the maintnence free.I have that inline on the #2 on the pergo emergency motor start only unless i choise to run the switch on the 1-2 both but I do not.Now this spring i bought the autocraft marine batt this batt is main free this batt runs off #1 on pergo switch so the motor is charging well butt not to safe when i see 17 volts.so after a long study i realize the main free batt may be some of the problem.My remedy when out on the water and i see the volts go into the red zone i put on all my lights I have a set of small flood lights i hooked up last year and when i hit the toggo for them my vollts drop to normall even at wot the volts maintain at a safe 12+ volts.Butt to me this is a pain in the arss.So come spring i am going to put the wally world everstart maxx27-n in place of the new main free marine batt and have that one for emergency back up.Ok with all this said i still have a unregulated system off of the 9 amp stator going to the rectofier CDI has made a new rec- reg PART#193-3408 THECOST 100.00VS THE 200.00 FOR THERE OTHER ONES.Has anyone out there tryed this new part?Hopefully it will help many of us with these older cdi ing systems.I have looked on different sights to see this part from cdi butt not much luck finding info on it .Butt i spoke to cdi teck team and this is there newest part.In fact he said it really is not a retro fit the old rec with 3 wires comes off and this new reg-rec takes its place.