Merry Christmas Everyone.
my problem for today is completely removing the flywheel on my old rusted Mercury 110 9.8 hp motor. I used a puller with a 5/8” bolt that allowed me to pull the fly wheel out as far as it will go till it touched the 5/8” bolt. The problem is the crank shaft bolt is only 1/2” and the two bolts are interfering with each other. But it did not break it free so I still need to pull it further off the crank shaft. I tried banging on it with a hammer and prying with a crow bar but it did not budge. I also thought about reducing the size of the 5/8” bolt down to say 1/4 “. Any thought would be appreciated.
stay Warm on a cold night. Jack the Moped Man
my problem for today is completely removing the flywheel on my old rusted Mercury 110 9.8 hp motor. I used a puller with a 5/8” bolt that allowed me to pull the fly wheel out as far as it will go till it touched the 5/8” bolt. The problem is the crank shaft bolt is only 1/2” and the two bolts are interfering with each other. But it did not break it free so I still need to pull it further off the crank shaft. I tried banging on it with a hammer and prying with a crow bar but it did not budge. I also thought about reducing the size of the 5/8” bolt down to say 1/4 “. Any thought would be appreciated.
stay Warm on a cold night. Jack the Moped Man