I have purchased a sender unit
I have purchased a sender unit for the alpha 1 so I can hook up the trim gauge .. the unit says I have to remove the stern drive.. has a sender for both starboard and port side of drive??? my question is how hard it this I have basic tools.. do I need any kind special tools.. other than general sockets sets and wrenches???
about my last post I found the leak on the starboard side in the boot.. same was on backside of the boot making it very hard to see..
but the 20' Marquis will run 45 MPH now.. I put on a edelbrock 4bb and high rise maniflow. with
4 blade 20 pitch 14 `1/4 prop.. does this sound like the speed it should run
thanks
I have purchased a sender unit for the alpha 1 so I can hook up the trim gauge .. the unit says I have to remove the stern drive.. has a sender for both starboard and port side of drive??? my question is how hard it this I have basic tools.. do I need any kind special tools.. other than general sockets sets and wrenches???
about my last post I found the leak on the starboard side in the boot.. same was on backside of the boot making it very hard to see..
but the 20' Marquis will run 45 MPH now.. I put on a edelbrock 4bb and high rise maniflow. with
4 blade 20 pitch 14 `1/4 prop.. does this sound like the speed it should run
thanks