Logo
FULL SITE MENU

Honda BF50 efi VST removal

B

Barrabella

Member
Hope someone can help. I need to remove VST to inspect/replace grommet on fuel pump. Is there somewhere I can find step by step instructions on how to remove VST. Have looked on Utube without any luck. Thank. you
 
www.ebay.com

Honda BF50D outboard VST/ fuel vapor separator 16730-ZZ5-M01 | eBay

<p>Hi I am selling this Vst with fuel pump removed from a 2015 Honda BF50D this was removed from a running motor that had a Powerhead failure other than that everything was working as it should please feel free to ask any and all questions and I will do my best to answer them for you thank you</p>
www.ebay.com

not sure this will you but it's a clear picture of what you're up against.

good luck.
 
Thank you. Just need to know how to remove VST from engine. Was hoping that there would be a video or something showing me how to go about the removal.
 

1999 DF70 stumbling/surging around 3500 and will not rev past 4200 RPM

I just mounted an old DF70, 1999 ( in Evinrude colors) to my 5,1m center console. It starts and idles like new (as far as I can tell). Acceleration is good and it runs smooth until it hits 3500-3700 rpm where it begins to stumble/surge, there is still a lot of travel on the throttle at this...
www.marineengine.com

Post #2 about 14 minutes in for VST removal. I’d suggest you watch the entire video, lots of good information
 
Back
Top