Greetings, I have a crusader 350 with GM block, 270HP, regular carb, no computers to deal with its a 1988. The engine catches when the key is turned and the starter kicks in as normal, however as soon as I let go of the key the engine cuts off. If I pump the key to keep the starter engaged the engine keeps running...obviously I only did this to test..
So I started to check and replace things. So far I replaced the ignitor in the distributor, new dist cap, new rotor, added ballast resistor thinking its a coil issue, even replaced the coil. Also checked fuel pump and also put on a new carburetor . Still starts then cuts off.
Any suggestions?
So I started to check and replace things. So far I replaced the ignitor in the distributor, new dist cap, new rotor, added ballast resistor thinking its a coil issue, even replaced the coil. Also checked fuel pump and also put on a new carburetor . Still starts then cuts off.
Any suggestions?