I have stalling isses on my starbord side 360. it seems to happen only when warmed up and after running a bit. I've stalled out at the dock, after backing down near idle speed when coming into a no wake zone etc.
yesterday, after 5-10mins of runnign at 3k RPM, the starboard gave up 500RPMs and then stalled. Limed back on one motor and after a while, tried the stalled motor and it started it up. Put it under load and then it stalled again. There is a brief period of roughness before it stalls. Waited another 10mins and it started up again and ran smooth but was careful not to exceed 1500 RPM. ran at low RPM without issue all the way back.
Also, carb is opening up just fine. when hot, it's wide open. carb was also rebuilt a year or two ago.
Lastly, not sure if this is related, but when at the dock, it's hard to start initially. sounds as if batt is dead although it's a new battery and is connected to a marine charge all week just like the other batt is for the port motor.
Could this be a failing coil?
yesterday, after 5-10mins of runnign at 3k RPM, the starboard gave up 500RPMs and then stalled. Limed back on one motor and after a while, tried the stalled motor and it started it up. Put it under load and then it stalled again. There is a brief period of roughness before it stalls. Waited another 10mins and it started up again and ran smooth but was careful not to exceed 1500 RPM. ran at low RPM without issue all the way back.
Also, carb is opening up just fine. when hot, it's wide open. carb was also rebuilt a year or two ago.
Lastly, not sure if this is related, but when at the dock, it's hard to start initially. sounds as if batt is dead although it's a new battery and is connected to a marine charge all week just like the other batt is for the port motor.
Could this be a failing coil?