I have a 1960 (Model 3034) 3hp Lightwin.
I was just on the water and the prop stopped spinning. The shear pin was still engaged. When I tested it in a barrel it was not pumping water so I am assuming the drive shaft is not being driven. I replaced the drive shaft 3 years ago and it fixed the problem.
I probably should of replaced the crank shaft at the same time.
The splines on the drive shaft and crank shaft look worn so I would like to replace both.
My question is how do I replace the crank shaft?
I was just on the water and the prop stopped spinning. The shear pin was still engaged. When I tested it in a barrel it was not pumping water so I am assuming the drive shaft is not being driven. I replaced the drive shaft 3 years ago and it fixed the problem.
I probably should of replaced the crank shaft at the same time.
The splines on the drive shaft and crank shaft look worn so I would like to replace both.
My question is how do I replace the crank shaft?