So I replaced the powerhead on this motor, did the impeller, fired it up and it runs great. I then discovered goo in the tank and the new leg oil has water in it. I rigged up a pressure tester that works great but discovered that it would not hold any pressure. I pulled the lower unit again (I wish I could figure out how to do that without removing the powerhead) and now I cannot get the driveshaft out of the lower unit.
The driveshaft seal needs to be replaced.
Is it stuck in there or why would it not come out ?
The driveshaft seal needs to be replaced.
Is it stuck in there or why would it not come out ?