[FONT="]Hi guys, bit of a novice here from Melb Australia. Have had this 1975 Evinrude 50 running quite well for a few years but rebuilt the carbs with new kit and replaced cylinder head gasket . Ran well for a while but noticed it bogged down when I tried to go full throttle . I have stripped it down and noticed corossion between the two cylinders . I'm not sure if it was there before? I think there was a bit of a hole but the salt water seems to have made I worse. Can anybody advise me what to do? I had a feeling I may not have retorqued the cylinder head bolts after running it and that's why the loss of power ? As I said , I'm mechanically minded but new to outboards. I've attached some pics , Any advice would be great! Thanks in advance , Ash[/FONT]
Attachments
-
thumbnail_20210123_162204.jpg315.5 KB · Views: 73
-
thumbnail_20210123_162207.jpg262.2 KB · Views: 74
-
thumbnail_20210123_162210.jpg247.8 KB · Views: 71
-
thumbnail_20210123_162222.jpg279.4 KB · Views: 53
-
thumbnail_20210123_162227.jpg270.1 KB · Views: 54
-
thumbnail_20210123_162240.jpg264.2 KB · Views: 43