Billhein94
Member
I am tuning up a 75 25HP (25502B) and I just replaced the points and condensers, but I can't seem to get the points adjusted to .020. They will not open that far with the adjustment screw. I had to push them open with my finger to get like a .019 gap and that was as far open as I could get them then I torqued down the screw to keep them in place. I move the plate around a couple of times and it appears to be holding. Out of curiosity, I put the flywheel back on and had good spark nice and blue jumping almost half and inch. Did I do something wrong or should I just roll with it?