Bugger, i just snapped a head bolt off and don't have much to grab with vice grips.
Can i use an arc welder to weld to it then lean on it again with heat and penetrol? Not sure if its stainless or not.
I think it is stuck in there properly though so am leaning to grinding it flush and drilling it out. Can a helicoil take the torque/load of a head bolt?
I don't want to take it to a machine shop so it will become a parts motor othewise.
Does anyone know the thread eg 1/4 unc so i can order a helicoil kit?
Can i use an arc welder to weld to it then lean on it again with heat and penetrol? Not sure if its stainless or not.
I think it is stuck in there properly though so am leaning to grinding it flush and drilling it out. Can a helicoil take the torque/load of a head bolt?
I don't want to take it to a machine shop so it will become a parts motor othewise.
Does anyone know the thread eg 1/4 unc so i can order a helicoil kit?