I converted my 2007 elec start, power trim, tiller BF40A to remote control/remote steering. I bought tach/trim 06300-ZW5-000KT and connected to Remote Ctl 24800-ZW4-H13. All color coded wires between gauges and motor were consistent.
The trim meter did not work and Faria replaced it. (Have not had a chance to test replacement.)
The tach is erratic. Spoke with Faria and they had me try all pointer settings which changed results but still erratic. Faria also said I needed 32197-ZH8-003 Sub-harness which hooks up between charge coil and tach sending wire. I now have the adapter. Neither Faria, Honda, or any local dealers are able to tell me how this adapter should be installed. The local dealer spoke with their Honda hot-line to no avail.
Voltages and grounds at the meter seem to be OK. I am being told that there is no other testing that I can perform on the harness.
I have the Honda service manual but cannot figure out how to do this install.
Any help would be much appreciated.
The trim meter did not work and Faria replaced it. (Have not had a chance to test replacement.)
The tach is erratic. Spoke with Faria and they had me try all pointer settings which changed results but still erratic. Faria also said I needed 32197-ZH8-003 Sub-harness which hooks up between charge coil and tach sending wire. I now have the adapter. Neither Faria, Honda, or any local dealers are able to tell me how this adapter should be installed. The local dealer spoke with their Honda hot-line to no avail.
Voltages and grounds at the meter seem to be OK. I am being told that there is no other testing that I can perform on the harness.
I have the Honda service manual but cannot figure out how to do this install.
Any help would be much appreciated.