dearborndeuce
New member
Hi Ya'll !
My O?Haul on my AQ151B is going well ( almost done & ready to install back in my boat ).
Due to my rusty oil pan, I picked up a perfect automotive one.
Everything looks identical except for the baffling ( inside rear of pan ).
My rusty original has a larger open rear area in the port/rear corner than the automotive one.
Is this a big deal or should i cut out the baffling to make it look the same ?
I'm trying to understand the logic as to why the marine OEM pan is slightly different ?
cheers Bob
My O?Haul on my AQ151B is going well ( almost done & ready to install back in my boat ).
Due to my rusty oil pan, I picked up a perfect automotive one.
Everything looks identical except for the baffling ( inside rear of pan ).
My rusty original has a larger open rear area in the port/rear corner than the automotive one.
Is this a big deal or should i cut out the baffling to make it look the same ?
I'm trying to understand the logic as to why the marine OEM pan is slightly different ?
cheers Bob