Hey all
I have a small crack on the fittings of my heat exchanger plastic housing.
These new are ridiculously expensive. Is this ok to use if I repair it with jb weld or something similar? It's not huge pressure from memory.
Here is a pic of the damage
I would like to get a new one but money is a bit tight right now
Thanks
I have a small crack on the fittings of my heat exchanger plastic housing.
These new are ridiculously expensive. Is this ok to use if I repair it with jb weld or something similar? It's not huge pressure from memory.
Here is a pic of the damage
I would like to get a new one but money is a bit tight right now
Thanks