jim18611865
Regular Contributor
See picture. I just want to make sure the impeller fins are the right way.
The drawing on my fixture was opposite, but I didn't write down if it was top view or bottom view.
All OMCs are the same correct?
Paper gasket first (with gasket sealer)
Metal plate next
Then housing with o-ring. I don't want to screw this up any more.
Should there be gasket sealer on the o-ring as well. This kit is different than the original. Upgrades I am sure.
Thanks
Jim
The drawing on my fixture was opposite, but I didn't write down if it was top view or bottom view.
All OMCs are the same correct?
Paper gasket first (with gasket sealer)
Metal plate next
Then housing with o-ring. I don't want to screw this up any more.
Should there be gasket sealer on the o-ring as well. This kit is different than the original. Upgrades I am sure.
Thanks
Jim