Hi Guys,
I have a 1973 20hp Johnson and I haven't used it for about 6 years, and as far as I can remember
the throttle control makings were accurate ie stop, slow, shift, start and fast.
I have put new oil in the gear box cleaned the plugs and new fuel, after some pulls it fired up great and
ran OK with a good tell tale flow.
The problem, it starts with control between shift and start but is running at full throttle just after the start
marking. The control will not turn to Fast, I have had the rod between control handle and the angled dogs
wheels out and replaced, what have I done wrong?
I have a 1973 20hp Johnson and I haven't used it for about 6 years, and as far as I can remember
the throttle control makings were accurate ie stop, slow, shift, start and fast.
I have put new oil in the gear box cleaned the plugs and new fuel, after some pulls it fired up great and
ran OK with a good tell tale flow.
The problem, it starts with control between shift and start but is running at full throttle just after the start
marking. The control will not turn to Fast, I have had the rod between control handle and the angled dogs
wheels out and replaced, what have I done wrong?