jimmygouge
Member
I took the 150 off of my boat, took it to a certified Honda service dept on another island and had it rebuilt ($7500). Picked it up and put it back on the bracket. Hooked up the shift and throttle linkage. I remember (I think) adjusting or loosening or tightening the connection between the Honda control stick linkage on the left side (facing motor front) and the throttle body on the right side.
Am I correct that there is a physical rod that connects the two. I put the boat in the water and have tried to get it up on plane but it wont get there. The motor under full throttle coming out from a dead start will not get up. Motor will not go over 3600-3800 rpms and thats just not enough to get up.
Its been 3 yrs since I re-installed the motor to the boat and cant seem to find a diagram that actually shows the linkage between the 2 points. Is there an adjustment to increase rpm at the throttle body or am i wrong.
Thank you;
please help, contact me at-----
[email protected]
Lopez Island, Wa
Am I correct that there is a physical rod that connects the two. I put the boat in the water and have tried to get it up on plane but it wont get there. The motor under full throttle coming out from a dead start will not get up. Motor will not go over 3600-3800 rpms and thats just not enough to get up.
Its been 3 yrs since I re-installed the motor to the boat and cant seem to find a diagram that actually shows the linkage between the 2 points. Is there an adjustment to increase rpm at the throttle body or am i wrong.
Thank you;
please help, contact me at-----
[email protected]
Lopez Island, Wa