littledutch
New member
Just had my powerhead rebuilt with all the fixings, rings, seals, gaskets etc. Took her to the lake and she started up fine, was a little rough idle but strechted her legs and she did well. Took her out on the water again a few days later. She had a little trouble starting but after a few times she started up and ran fine the rest of the day. Yesterday took her out for the 3rd time but before going I ran her with the hose at the house. All is fine. Get to the ramp and she starts up but goes dead. Tried many mroe times and finally got her cranked and throttled up. Few minutes later went to throttle her up to make a short run. She felt like she was choking down and went dead. Have not been able to crank her after that. No alarms of any kind.
Note: I did not replace the sparks plugs during the rebuild. They are two years old and a couple look like they could be fouled.
Any suggestions?
Note: I did not replace the sparks plugs during the rebuild. They are two years old and a couple look like they could be fouled.
Any suggestions?