ssantelman
New member
I bought this motor new in 2013, s/n 0R484683
It will be running with an open throttle with no issues until crossing a wake (at an angle). The slap of the hull from dropping into the trough will cause the motor to cut out. At this point it would only idle. If the throttle is opened, the motor will sputter to a stop.
After idling (in gear) back to the dock and then idling a few minutes out of gear, the motor ran fine.
Has anyone had a similar experience? Any suggestions?
Thanks
It will be running with an open throttle with no issues until crossing a wake (at an angle). The slap of the hull from dropping into the trough will cause the motor to cut out. At this point it would only idle. If the throttle is opened, the motor will sputter to a stop.
After idling (in gear) back to the dock and then idling a few minutes out of gear, the motor ran fine.
- This happened twice on consecutive days.
- This does not happen on every wake that is crossed
- The fuel is new, no ethanol, Sea Foam added
Has anyone had a similar experience? Any suggestions?
Thanks