"My motor suddenly stopped fir
"My motor suddenly stopped firing on one bank.
The timer base and the stator checked out OK; the power pack did not
I changed out the PP. It fired on all cyl’s for a few seconds and quit.
It would seem by what I have read that my rectifier is bad. But I’m stumped.
The procedure I used for testing it was black test meter lead to rectifier ground and the red meter lead to the yellow and red rectifier wires, then reverse the procedure. I had disconnected all the leads from the rectifier before testing.
My problem is that I got an ohm reading both ways. The procedure said a good unit should have ohms one way and no ohms the other way. It does not say what to conclude if an ohm reading is in both directions.
I am by no means an electrical whiz. Is my rectifier checking the way a bad rectifier should check?"
"My motor suddenly stopped firing on one bank.
The timer base and the stator checked out OK; the power pack did not
I changed out the PP. It fired on all cyl’s for a few seconds and quit.
It would seem by what I have read that my rectifier is bad. But I’m stumped.
The procedure I used for testing it was black test meter lead to rectifier ground and the red meter lead to the yellow and red rectifier wires, then reverse the procedure. I had disconnected all the leads from the rectifier before testing.
My problem is that I got an ohm reading both ways. The procedure said a good unit should have ohms one way and no ohms the other way. It does not say what to conclude if an ohm reading is in both directions.
I am by no means an electrical whiz. Is my rectifier checking the way a bad rectifier should check?"