RickJamesBish
New member
The Power Trim from throttle control is not working. It worked prior to taking the engine in for carb rebuild but I did not notice it was not working immediately since it was winterized shortly after and stored. When I did notice I took it back to the mechanic but he stated nothing he did would have caused that. I traced the wire that comes out of the bottom of the throttle control back to the engine and found a 5 pin plug at the end not plugged into anything, nor could I find anything to plug it into. The plug is located just a few inches inside the front corner of the housing.
Any ideas? Am I tracing the wrong wire? If this is the correct plug, then it would appear someone removed the part it plugs into and even if I had that part, I am not sure where the other end would go. The control on the engine itself does work.
Any ideas? Am I tracing the wrong wire? If this is the correct plug, then it would appear someone removed the part it plugs into and even if I had that part, I am not sure where the other end would go. The control on the engine itself does work.