tomjeffcoat
New member
I am new to the forum and needing some advice.
I have a 1991 Mercury Black Max 2 cycle and after starting the alarm just keeps beeping. I do get the 2 beep after turning on the ignition.
Checked the water and after warm up getting good stream out of output.
Motor cranks and runs great. It happened while fishing and had to run the boat back to the dock. It can run full speed and not stutter in the performance.
Smooth running. Have 3 bank charger and all the batteries are full charge.
checked the top oil tank and it is full as well as the 3 gal on board tank.
On thing I have noticed is the AMP gauge sets right at 12 volts and does not move upward while running.
any suggestions are welcome.
thank you.
I have a 1991 Mercury Black Max 2 cycle and after starting the alarm just keeps beeping. I do get the 2 beep after turning on the ignition.
Checked the water and after warm up getting good stream out of output.
Motor cranks and runs great. It happened while fishing and had to run the boat back to the dock. It can run full speed and not stutter in the performance.
Smooth running. Have 3 bank charger and all the batteries are full charge.
checked the top oil tank and it is full as well as the 3 gal on board tank.
On thing I have noticed is the AMP gauge sets right at 12 volts and does not move upward while running.
any suggestions are welcome.
thank you.