Some time back I replaced the water pump impeller. I must have turned the shift rod when I reinstalled the lower unit because now when in reverse it , 'clunks' occasionally when backing up. - (This can't be good for the gears!) It runs fine in forward. I have tried adjusting the shifter cable but it does not seem to help.
I read that the Shift Rod Height should be 15-29/32" (+/- 1/32)
Question: How do I measure this? Do I need to pull the lower unit back off? If I don't need to pull the lower unit looks like I need to pull the carbs???
Suggestions greatly appreciated!!
I read that the Shift Rod Height should be 15-29/32" (+/- 1/32)
Question: How do I measure this? Do I need to pull the lower unit back off? If I don't need to pull the lower unit looks like I need to pull the carbs???
Suggestions greatly appreciated!!