Good Morning,
I am replacing my thermostat as preventative maintenance on my 70HP Evinrude. Old one tested ok (original), however, I wanted to check the passages to see how bad they were. They turned out normal. My question is - in both my Factory Manual and Clymer Manual, I am having a hard time determining the proper torque for the bolts. Also - I do not have access to the OMC/Evinrude gasket sealant. What is best used in place of this? Thanks in advance!
I am replacing my thermostat as preventative maintenance on my 70HP Evinrude. Old one tested ok (original), however, I wanted to check the passages to see how bad they were. They turned out normal. My question is - in both my Factory Manual and Clymer Manual, I am having a hard time determining the proper torque for the bolts. Also - I do not have access to the OMC/Evinrude gasket sealant. What is best used in place of this? Thanks in advance!