Hi guys been working on my old outboard not been ran in over 10 years done carbs and hoses. Tried to remove the screws for the impeller housing and no joke all 4 screws snapped so I have had to drill them out…
question anyone know the size and thread I need to tap them to? Iv looked in service manual doesn’t tell me.
my plan is to fill the holes I have made drilling them out with some aluminium welding rods and then drill and tap.
any help would be appreciated
question anyone know the size and thread I need to tap them to? Iv looked in service manual doesn’t tell me.
my plan is to fill the holes I have made drilling them out with some aluminium welding rods and then drill and tap.
any help would be appreciated