TroyHanson
New member
I have picked this motor up recently. It came with controls. After finally getting everything reconnected the way I believe it should go. I was able to get the dash light to come on when turning on the key. Then the choke switch activated the chokes. I was able to supply power to the green wire to get it into neutral or to the blue wire and got reverse. However I have not been able to get spark while Starter is going through it’s cycle, but... At the end of each starter cycle there is usually a random 3 sparks out of the plug. I have so far been told that somehow it may be back feeding because of a bad ground. Any help or wiring diagrams for this specific set up would be appreciated. I have found plenty of diagrams just not this exact setup. Thx