Hello,
New to the forum and new to outboard motors, but mechanically inclined. I recently picked up this motor , boat and trailer. After reading many posts I decided to go through the motor (rebuild carb, replace ignition items and change impeller - which turned into replacing lower seals after seeing milky gear oil). It's actually going pretty well thanks to all of the posts and videos out there. However, I ran into an issue removing the 6 bolts of the gear casing. I was able to get 5 out using an impact driver. The last one is starting to strip the head. First question is how to get the screw out without further damage. Once out, has anyone been able to use an alternate screw?
Thanks,
Steve
New to the forum and new to outboard motors, but mechanically inclined. I recently picked up this motor , boat and trailer. After reading many posts I decided to go through the motor (rebuild carb, replace ignition items and change impeller - which turned into replacing lower seals after seeing milky gear oil). It's actually going pretty well thanks to all of the posts and videos out there. However, I ran into an issue removing the 6 bolts of the gear casing. I was able to get 5 out using an impact driver. The last one is starting to strip the head. First question is how to get the screw out without further damage. Once out, has anyone been able to use an alternate screw?
Thanks,
Steve