Mikeski1021
Member
Seemed to be?
Takes 2 seconds to undo the screw and retighten.
Carbs are definitely synced
MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.
Seemed to be?
Takes 2 seconds to undo the screw and retighten.
I just rebuilt a 98/120
The motor fell off the pontoon it was on into
salt water and wasn't properly cleaned out.
It set for a year or more with salt water in it.
The carbs full of salt water so we replaced them.
I didn't adjust the bar on the new carbs
and the motor ran like crap.
That's why I was so anal about the bar and it
being set right????
I just rebuilt a 98/120
The motor fell off the pontoon it was on into
salt water and wasn't properly cleaned out.
It set for a year or more with salt water in it.
The carbs full of salt water so we replaced them.
I didn't adjust the bar on the new carbs
and the motor ran like crap.
That's why I was so anal about the bar and it
being set right????
I removed each coil and tested with a multimeter.
#1 primary .5 secondary .99
#2 primary .5 secondary 0
#3 primary .5 secondary 0
#4 primary .5 secondary .26
On the 2 with 0, the plug wire is spinning in the pack.
# 4 is a black coil and is cracked. The other 3 are the blue ones.
Did I check these right? Watched YouTube video and read instructions.
Sounds like a key switch problem?
Or a wire's not hooked back up?
outboardignitiondotcom or call CDI
http://www.cdielectronics.com/
Try spraying WD 40 IN the switch and turn it on/off/pushing in
on the choke a bunch of times(battery unhooked)
The difference in the coils isn't something that would keep the motor running when turned off.
The main difference is the connectors on the blue and black is they are backwards and can't be used together.
The blue packs can't be hooked too the black coils without cutting the connectors off and using butt connectors.
Is the kill switch even hooked up?
Sounds like the wrong key switch????
SWITCH, IGNITION LONG BARREL W/KEYS AND SCREWS *{(ACCESSORY ITEM)}* F5H078 [COLOR=#009A00 !important][FONT="][/FONT] If you need the wiring diagram I have one, I can post it, if needed???[/COLOR] | $66.75 $65.18 |
SWITCH, IGNITION LONG BARREL W/KEYS AND SCREWS *{(ACCESSORY ITEM)}* F5H078 [COLOR=#009A00 !important][FONT="][/FONT] In Stock[/COLOR] | $66.75 $65.18 |