M
Michael Tierney
Guest
" I have a 1977 Chris Craft wi
" I have a 1977 Chris Craft with an original 305 in it. When it is cold, it starts very easily without hesitation. When the motor is running it is extremely smooth. After it has been warmed up and shut down, it will only start if I crank the starter for 5 to 7 seconds and only after I release the starter. I was told that it might be a ballast resistor problem but it does not have one to the best of my knoledge. I have put in a new ignition coil and I have also checked the choke to make sure that is operating properly.
Any thoughts or suggestions would be appreciated.
Thank you.
Mike "
" I have a 1977 Chris Craft with an original 305 in it. When it is cold, it starts very easily without hesitation. When the motor is running it is extremely smooth. After it has been warmed up and shut down, it will only start if I crank the starter for 5 to 7 seconds and only after I release the starter. I was told that it might be a ballast resistor problem but it does not have one to the best of my knoledge. I have put in a new ignition coil and I have also checked the choke to make sure that is operating properly.
Any thoughts or suggestions would be appreciated.
Thank you.
Mike "