Logo
FULL SITE MENU

Search results

  1. J

    2006 Honda 150

    I took the 150 off of my boat, took it to a certified Honda service dept on another island and had it rebuilt ($7500). Picked it up and put it back on the bracket. Hooked up the shift and throttle linkage. I remember (I think) adjusting or loosening or tightening the connection between the...
  2. J

    Rebuilt 2006 150 wont get enough rpms to get on plane

    I took my 150 off of the boat to a Honda dealer (to the mainland). A complete rebuild (new short block) has been done. I reinstalled the motor on the boat and rehooked up the linkages, gas, etc. Boat in water now will not get enough rpm's to get up on plane (3300 +/-). I dont want to take...
  3. J

    2006 Honda 150 oil around flywheel

    Hi- Last year I had lots of fine powdery dust (grey) in the flywheel / starter motor area. There was so much there that the starter motor would growl and then finally after a few weeks it just would not work at all. Pulled the starter and I devised a vacuem tube and removed most (I think) of the...
  4. J

    2006 Honda 150 Starter

    My 150 starter is not working. It makes a low growling, somewhat quiet noise, I dont believe that the unit is engaging the flywheel at all. Motor has 3-400 hours, starting battery is fully charged. Wondering if anyone has run across this condition, starters are about $150 to $175, from my...
  5. J

    06 honda 150 performance

    I converted from 4.3 / volvo od to a full bracketed 06 Honda 150. Boat is a 19' enclosed cabin heavy duty Seasport \150 is pushing about 4000 lbs. I am working on weight distribution, needs more up in the bow (has 2 bags of sand, 160 lbs). At 3200 rpm it is planing at 30 mph (per Garmin...
  6. J

    Small rooster tail

    I have a 1989 19' Seasport w/full alum Bracket (adds 2' and then motor for another 24". Weighs about 4000 lbs with Honda 150 and Honda 15 kicker. My main 150 Cavitation plate is about 1 1/2 inch below "bottom of hull line". I get a small roostertail about 25' behind the 150. It is about 24"...
  7. J

    First Post ---2007 Honda 150- stutters then dies

    My new to me 07 - 150 first time trying to fire it upm (bought 2 yrs ago- sitting since)- I have converted old 19' seasport to outboard w/nice alum bracket 300 hr, 190 cold compression all 4---- primer pumped correctly -fresh gas- no start just a few stutters (1-2 seconds) --changed fuel...
  8. J

    2007 150 vs later models- major differences or any preferences ?

    Hi; I am going to get Honda 150 for my enclosed cabin 19' Seasport. I have a chance to pick up an 07 with 700 hrs w/great maintenance or should I get a later model. Are there any major differences? Thanks Jimmy Lopez Island, Wa
Back
Top