Logo
FULL SITE MENU

Search results

  1. D

    99 hp johnson

    I have a johnson 9.9.Can some I have a johnson 9.9.Can someone tell me fuel to oil mix and year mod. mod=MQ-11C SER= J2529998 THANKS san
  2. D

    1977 140HP Evinrude wrong waterpump

    "Hey all, I may have a problem "Hey all, I may have a problem here. I bought a water pump kit for my 1977 140 HP Evinrude, the part number was 395073, as called for in my OEM parts manual. The problem is that the impeller keyway on my outboard is teardrop shaped, like this...
  3. D

    1977 140HP Evinrude waterpump sealant

    " Getting ready to replace the " Getting ready to replace the waterpump in this motor. The service manual calls for "OMC Adhesive M" to be used on the seal in the waterpump housing. I have a can of OMC gasket sealant, is this the same thing, or is there a generic equivalant I can use...
  4. D

    Hook up forks for a duo prop

    "I have a 1990 aq205 volvo and "I have a 1990 aq205 volvo and i need 2 hook up forks, i have twin duo prop out drives, can any one help??? email me at{[email protected])"
  5. D

    1972 Evinrude Sportwin 95

    I recently acquired a Sportwi I recently acquired a Sportwin 9.5 model # 9222 and it is missing the piece or plate that stabilizes the motor so it doesn't go into a turn when you let it go. I am looking for the part number or name of this piece. If anyone can give any help it would be greatly...
  6. D

    Evinrude 135 Starflite

    I am looking for the lower ho I am looking for the lower housing for the Evinrude 135 Starflite(dont know the model # and I have no access to it to check) I have little idea what year it is. It is mounted on an 1973 18' Reinel and from pictures I saw of other 135's it looks to be a 73-76+...
  7. D

    Marine Conversion kits for Dodge Cummins 6b engines

    Someone in an earlier post as Someone in an earlier post asked about marine conversion of the Dodge Cummins engines. The company in Texas that sells that kit is H&S Marine services. 979 849-3088 Their web site is www.hsmarineservices.com
    • dan
    • Thread
    • Replies: 5
    • Forum: Cummins
  8. D

    JoeNeed help with an 86 Johnson 150 hp

    " I actually have two unrelate " I actually have two unrelated problems. The first is with my starter. When starting the engine it will only stay engaged for a few seconds. The engine will usually start on the second or third try.Batteries have been charged, Do you suspect the starter itself...
  9. D

    58 Evinrude Lark

    58 evinrude 35 hp absolutly w 58 evinrude 35 hp absolutly will not pump water to the upper part of the engine.I have installed new impeller and tube seals.I made sure the seals went into the seals while installing lower unit.I have checked the thermostat with water and thermometer.What am I...
  10. D

    58 lark 35 hp High speed needle valve

    I have a lark that had a gunk I have a lark that had a gunked up carb.and didnt run well at all"very rich" I went through carb at my shop and discovered that the high speed needle was blunt on the end but doesnt look broken off.In any pictures I have seen its a needle like the low speed.Am I...
  11. D

    Loss of power and speedPossibly prop related

    " First...Thanks to those who " First...Thanks to those who have helped me in the past! I hope this one is easy. Last year, my 1976 Bayliner ran 32 mph @ wot.(4800 rpm) It has a Volvo 170. It would plane in about 8 seconds. The last time I took it out, I destroyed the prop. Over the winter I...
  12. D

    OMC SternDrive 190

    Does anyone know where I can Does anyone know where I can locate the impeller in this outdrive? And is it a very hard project to replace?
  13. D

    Carburator Adjustments for a Volvo AQ170

    I have a 1978 Bayliner w/ a A I have a 1978 Bayliner w/ a AQ170 Volvo engine. It has three single barrel carbs. Can anyone please tell me the most accurate way to adjust the air/fuel mix on the three carburators. The engine appears to be running rich. (Black exhaust and carbon build-up on the...
  14. D

    Omc question

    " i have an 84 115 vro . i was " i have an 84 115 vro . i was wondering how many gallons of gas i would be burning an hour at W.O.T ? i only have an 18 gal inboard tank and i was curious as to how long i could go on that , "
  15. D

    Wholesale SIERRA Parts source

    Does anyone have a source for Does anyone have a source for ordering Sierra parts at a substantial discount? The mark-up on these parts is 50%!
Back
Top