Logo
FULL SITE MENU

Search results

  1. P

    59 evinrude 10 hp

    Two questions: 1. what is compression specs on this motor? Why will the engine dry start at home but won't start in the water at the lake and sometimes starts fine after warm up, sometimes not.
  2. P

    1959 evinrude 10 hp

    Opened mid section to replaced bushings, sleeves, dry rotted mounts etc. there is a butt load of grease inside but no grease fittings Do I pack it full of new grease during assembly. use only a little grease, or use none? The issue was poor handling during turns and lots of slop in steering...
  3. P

    sludge dripping from bottom of housing

    Took my boat to Suwanee river this week, ran it full throttle and at idle speeds seem to run fine. Noticed the day after gray sludge running from hole just above the prop. I could tell the hole was supposed be there. Is this ok or do I need to replace a seal some where in the upper housing...
  4. P

    59 10 hp evinrude thermostat

    Got old 10 hp running really good and was reading posts about these old engines when I noticed one talking about stuck thermostat. I check my engine and found the thermostat had been removed, So here's the question is it nessacary to have a thermostat. Als doe a worn prop affect the...
  5. P

    1959 evinrude 10 hp

    where does my 10 hp weep/ peep from? Is oil on top of water normal when running in a tank?
Back
Top