Logo
FULL SITE MENU

Search results

  1. T

    Digital trim limit switch question

    New to me boat. My starboard trim gage wasn't working so pull switch and cleaned contacts. I think it is the gage. But looked at port trim limit and it is the three wire boat is smart craft ready but no smart craft yet. Checking trim limit positions and drive raises they them using trim on...
  2. T

    496 mag spark plug wire question

    Changing my plug wires on my 2005 Mercruser 496 Just want to verify that that wire from the coil pack goes directly to the spark plug under neath each coil. Thanks
  3. T

    Rinker 360 with Mercruiser 496 twins with Bravo 3's

    Thinking my adjusting my bravo 3 tilt trim limit pin to get a benefit from having the bushing in the trim max-in position as is standard with the Bravo I. My boat seams to be riding bow high and I have to add trim with the tabs to keep the bow down unless I'm in the upper engine rpms. I believe...
  4. T

    Mercruiser 496 Mag Maintanance

    Getting ready to change exhaust flappers, plugs and wires, remove injectors to be flow tested and cleaned, and replace a sea water pump. looking for any helpful advise from forum. Just bought the boat 2005 Rinker 360, twin mercruiser 496 Mags with bravo 3 drives. bellows and shift cables will...
  5. T

    1989 180 / 3.7LX*4bbl. mercruiser fuel filter questions

    I believe there are two fuel filters on this engine one in the fuel pump itself one on the carb. With one if any is usually dirty. Just got the boat and want to change them before launching. Thanks
  6. T

    Water pump rebuilding Question on Alpha One Drive

    Just rebuilt 2 (Twin Drives) water pumps The upper seal where the drive shaft goes into the upper housing is shot. Anyone have that seal number. I read some where that when installing the lower not to use the oring on the drive shaft as this wreaks the seal on install, (the newer shafts have no...
Back
Top