Logo
FULL SITE MENU

Search results

  1. F

    Johnson 115hp/1984 how many pulses comes from tacho wire / rpm

    Don't know about today's stuff, but in bygone years every mechanic had a remote starter button in his toobox. Simply clips to the starter solenoid. Should have them at your local auto parts store.
  2. F

    Butterfly choke

    Post #12
  3. F

    Need help with identification

    That hand-etched number likely is a previous owner's Social Security number. Done to identify the motor if stolen.
  4. F

    Re placing plug wires and coils on my 9.5 evinrude

    Actually, it looks pretty good. You can squirt a bit of oil on the seal and rotate the shaft a few times. See bubbles? If so, the seal is leaking. People tend to over lube the mounting rings. Just a light smear is all that is needed. Excess gets lignified by vibration and fouls the breaker...
  5. F

    1959 Jonny 35

    As said, generator wires come in from side plug, and won't be connected to anything if no generator kit is installed. They are yellow and blue wires. But people often would appropriate for some other use.
  6. F

    1959 Jonny 35

    Can't make out exactly what wires you are holding. Probably generator wires for use when a generator kit is installed. If no generator, the wires won't be connected to anything. Unless somebody has connected them for some untended use.
  7. F

    FD-11 gear case repair

    How's the pinion bearing? It's cast in place also. Since you have a mill, you probably can bore out the old bushings and make new ones. I assume you have the skills? I'd use 932 bearing br0nze if I were doing it. That sludge in the can is the oil you put in the gas. Normal. Don't jump to...
  8. F

    Oil coming out exhaust

    For best results, you should start a new thread of you own instead of attaching to a 2009 thread.
  9. F

    What year is this motor on the left?

    https://web.archive.org/web/20051215124410fw_/http://www.old-omc.de/e_1960/seite_08_09.jpg
  10. F

    What year is this motor on the left?

    UM, I think 1960. An honest fat-fingered mistake
  11. F

    1955 Johnson 10 hp QD-16 rebuild

    19-51 is changed to 306392 (0306392). Available right here.
  12. F

    Fuel pump / regulator rectifier

    Not the rectifier. I think you probably have a wiring problem. Loose or shorting wires or such. Check the 12V supply to the tach and/or the ground. Possibly even an intermittent ACC feed from the key switch.
  13. F

    1975 Evinrude 115 hp Fuel Pump

    You rarely can go by numbers embossed on castings. I assume that is what you are looking at? Those are part numbers for the raw casting.
  14. F

    Power pack

    Possible, but don't jump to conclusions. More testing is needed. Model number is???
  15. F

    Evinrude 1958 25034 driveshaft

    Ther is a groove around the splined area of the drive shaft, for an o-ring. The splines are to be lubed with a light coat of grease upon assembly, and the o-ring keeps water out of them.. If water does get into them, the splines will rust away from the steel crankshaft. The drive shaft...
  16. F

    1989 Evinrude 88 SPL (E88MSLCER) Exhaust Housing Leaking???

    And I was so sure that (72) was it. You evidently has a situation I haven't experienced. Sorry I can't be of more help.
  17. F

    1969 Johnson 40hr eletramatic motor

    Electromatic means electric shift. The red lever allows you to give it a little bit of throttle to start and warm up the motor without putting it in gear.
  18. F

    Threads flywheel big twin 1965 40 hp

    1/4-20. Now start a new thread of your own.
  19. F

    1989 Evinrude 88 SPL (E88MSLCER) Exhaust Housing Leaking???

    Oops, forgot the picture #72
  20. F

    1989 Evinrude 88 SPL (E88MSLCER) Exhaust Housing Leaking???

    Seal #72 missing
Back
Top