Logo
FULL SITE MENU

Search results

  1. whaler__pr

    Evinrude 225 Ficht Ram 2003 and Evinrude 225 1993

    Hi everyone again!! I am upgrading to a bigger whaler and I have these engines... One is a 2003 Evinrude 225Hp Ficht Ram in a 20 Outrage and the other is a Evinrude 225 1993 in a 18 Outrage... Are these engines reliable?? Problems with these engines? If the 1993 225hp is already repaired, is is...
  2. whaler__pr

    small vent hole under water intake...

    leaking lower unit grease in a small hole under the water intake... what seal or retainer needs to be replaced? thanks in advance!
  3. whaler__pr

    Amsoil Saber Outboard users please report experiences!!

    Amsoil users... Iv'e been using this oil at 100:1 as stated, no problems in my engine, about 18 gallons used... I have a 40 Evinrude and checking in and between and no loss of compression... so far so good... I need inputs here on everyone using this oil...
  4. whaler__pr

    1986 40hp Evinrude

    picture for reference
  5. whaler__pr

    1986 Evinrude 65hp 3 cylinder

    Hello everyone!, I need some advice for my friend's engine, a 1986 Evinrude 65hp engine. What degrees for Engine timing at idle and maximum advance, Spark plug gap, the cam has 2 lines, the same in my engine "1986 40hp VRO" should the roller needs to touch the upper or lower line on the cam...
  6. whaler__pr

    Amsoil Saber 100:1

    Does someone knows of engine failures using Amsoil Saber at 100:1? Or losing compression?
  7. whaler__pr

    1986 Evinrude 40hp wiring

    Hello everyone again! Where can I find the wiring diagram for this engine?
  8. whaler__pr

    Exhaust cover

    Did anyone here knows how to r Did anyone here knows how to remove the exhaust cover from a evinrude 1986 without taking the power head off? Thanks anyone!!
  9. whaler__pr

    Evinrude 40 hp 1986

    Trying to get off the exhaust Trying to get off the exhaust cover from the engine. It have a bracket that holds it and in its sides are two mounts screwed into the middle unit but the bracket does not allow me to take the mounts off to lower the cover. Help here appreciated. Thanks!!!!
  10. whaler__pr

    Stabilizer goes bad

    "Recently installed a hydrofoi "Recently installed a hydrofoil, a stabilizer to my outboard. It is a Evin 40 HP 1986 and then suddenly the boat starts to jump in a flat lake water and when I saw the engine, the engine was loose. The engine is loose in the top of the transom, I think it is a bad...
Back
Top