Logo
FULL SITE MENU

Search results

  1. W

    AQ131C resistor wire

    I have twin AQ131C engines with standard point/condenser ignition. Starboard engine has on occasion stalled at low RPM after running normally for hours, restarted after a 5-10 minute waiting (cool down?) period. Never stalls if I connect a jumper wire from the battery positive terminal to coil...
  2. W

    SPC steering helmet pivot pin

    "Does anyone know the Volvo pa "Does anyone know the Volvo part number for the SP-C pivot pin - the type with the 6mm threaded hole on each side for jacking bolts? I found the part number for the other type, without the threaded holes, but that's not what I need to replace."
  3. W

    290 pivot pin

    "What size is the threaded hol "What size is the threaded hole in the pivot pin, item 72 in this link? http://www.volvopentastore.com/CONNECTING_COMPONENTS_AQ_DRIVE_UNIT_290_A/dm/cart _id.573633548--session_id.593789774--view_id.324016 I need to make a tool for pulling the pins to replace the...
  4. W

    SP drive variants

    "The tags on my SP drives are "The tags on my SP drives are stamped "SP-C" variety (one has part number 872202, the other 854019). The drives have hydraulic trim but no tilt. In the parts lists available on line I see SP-A and SP-A/MT, but not SP-C. For the purpose of ordering parts that can...
  5. W

    AQ131C SP drive repair

    "There are several problems wi "There are several problems with the starboard drive on our houseboat: one leaking trim cylinder, one broken trim cylinder rod end, and inoperable retaining pawl mechanism. I assume that one can remove/replace these parts without fully removing the drive from the...
  6. W

    AQ131C block fitting

    "This fitting is located on th "This fitting is located on the starboard side of my 1989 AQ131C block near the bellhousing. It appears to have a hose barb on it. Does the B230 block have a coolant passage fitting at this location? fitting
  7. W

    Replacing circulating pump AQ131C

    "In another post it was sugges "In another post it was suggested that the owner of a boat with AQ125A engine replace the circulating pump with a marine pump, not automotive. Is this also true of the AQ131C which uses a different pump (VP p/n 1378809 or 271975) than the AQ125A? If VP pump is...
  8. W

    Crankshaft pulley removal

    "I have twin AQ131C engines, 1 "I have twin AQ131C engines, 1989 vintage, and plan to replace the timing belts. Seloc describes removal of bolts holding the crankshaft pulley in place, but my engines have a single large bolt and washer. Can I use a standard gear puller to take the pulley off...
Back
Top