Logo
FULL SITE MENU

Search results

  1. V

    Bent shaft

    "Blew up my lower unit last su "Blew up my lower unit last summer on 1987 48hp evinrude,rebuilt it with new gear set and seals,after i got it back together i noticed the upper shaft was a little bent,how much can this shaft be bent and still be ok,need advice from the experts, thanks ps...
  2. V

    Bearing Question

    "Just put seal kit in my 1987 "Just put seal kit in my 1987 48hp evinrude lower unit, when i was putting seals in rear bearing housing i noticed seals were close to the needle roller bearing, looked like the bearing was not seated so i tapped it on down to the bottom where it looked like a...
  3. V

    Sealant

    "I`m rebuilding lower unit on "I`m rebuilding lower unit on a 48hp evinrude, service manual says to use sealant on orings and gaskets, anyone any suggestions on what this sealant is? or do you even need it?"
  4. V

    Gearset

    "I`m putting a new gearset in "I`m putting a new gearset in my 48hp evinrude and not sure about shimming the input shaft, would like to know how and why you shim this shaft?"
Back
Top